帖子一览:PVC to Standard steel pipe connection (新回复在最前,最多列出 6 个) [列出所有回复] |
Kelso |
发表于: 2005/02/11 04:11am |
It doesn't matter what you use. What you need is a spec break in your drawing.
|
|
max123 |
发表于: 2005/02/11 02:46am |
depends. it will be a piping ISO, or piping detail drawing typically for all these kinds of connections, but should be shown on P&ID.
|
|
waters |
发表于: 2005/02/10 09:04pm |
I mean if list those connections (if I have more than one ) one by one in a spec sheets or mark them out in dwgs like PID or ...
|
|
max123 |
发表于: 2005/02/10 08:23pm |
don't understand your question
|
|
waters |
发表于: 2005/02/10 05:11pm |
Do you spec them one by one or as a whole?
|
|
MAX123 |
发表于: 2005/02/10 04:34pm |
I met this Problem two days ago. they call it PVC adaptor, or use coupling + flange + nipple, then connect it to CS pipe.
|
|
|
© 中文版权所有: 卡尔加里华人论坛 本论坛言论纯属发表者个人意见,与 卡尔加里信息中心论坛 立场无关
|
|